Set of sliders for adjusting the hardness of 140 cm slatted Frames Comfort 38mm
Reinforcement set hardness adjustment suitable for 140 (2x70) cm wide slatted frame / for wooden slats with a thickness of 8mm and width 38mm
Simply retrofitting the slider turns your simple slatted frame into an individual and comfortable slatted frame.
For retrofitting a simple slat, two sliders and an additional, shorter slat are required, as there are 2 slats on top of each other when the hardness is adjusted. You can order the slats in our shop. Please note that the second bar should always be correspondingly shorter (consider the length of the caps/holders!) than the carrier bar.
Set includes:
2x8 wooden slats, 8 mm thick and 38mm wide, made of beech, quality laminated wood; slightly curved, naturally glazed
Length of each wooden slat 58 cm (fits our 68.5 cm wooden slats / 140 (2x70) cm slatted frames)
2x16 plastic slides in blue, each size:
Outside: width 600mm x height 23mm x depth 400mm
Inside: width 540mm x height 19mm x depth 400mm
MEASURE & ORDER:
Before you order your tailor-made sliders for adjusting the degree of hardness, it is important that you carefully and precisely measure one of your old spring wood slats (on the cut edges, without a bend!).
The sizes of the sliders refer to the thickness/height of ONE bar, but then they fit on two bars that are on top of each other!
Center zone adjustment with sliders
An additional bar is attached to the middle zone bar from below with ring-shaped sliders. If the sliders are on the outside, the strips work together against the force from above. If you push the rings in towards the middle, the groin becomes more flexible - you lie softer.
Information
Easy self-assembly with assembly instructions.
The price does not include decoration.
The colors shown may differ from the actual colors depending on the monitor and screen resolution.
